Store

HomeTile AdhesiveREYNOSTYLE TAC 2T 315

REYNOSTYLE TAC 2T 315

POLYMER BASED FLOOR & WALL TILE ADHESIVE

Tile Adhesive Cementitious complies to the adhesion requirements of IS 15477: 2019 Type 2T “Specification for Adhesives for use with Ceramic Tiles.” Also complies with EN C1 Classification.

SKU: TAC2T315 Category:

Description

PRODUCT Description

FAB ( Features, Benefits & Advantages )

Polymer modified cement adhesive for both interior floor and wall applications, and for exterior floor
applications.

• For installation of vitrified/fully vitrified tiles, glass mosaic tiles and all stones.
• Suitable for installations where background and location is more demanding like wet areas, submerged
areas, etc.
• Adhesive appropriate for tiles with porosity less than or equal to 3 percent.
• For installation of tile size more than 300mm x 300mm size.
• To install tiles on to various substrates like Concrete: Concrete Masonry, Cement Mortar Beds, Cement
Plaster; Existing Vitrified Tile & Ceramic Tile; Brick Masonry; Cement Terrazzo; Existing Natural Stone
• Can be fortified with latex admix for use on external Wall area.

Coverage

Approx. 50 to 55 sq.ft. per 20 Kg pack, using 6mm x 6mm square notched trowel for a bed of 3mm. Coverage
will depend on the nature and flatness of the surface and the method of application. For good coverage, it is
must that all surfaces are smooth, plumb, level and free from defects and undulations.

Mixing

– Add Tile Adhesive to clean water.
– Mix thoroughly by hand or with a slow speed mixer to obtain slump free mortar for a trowelable consistency
– Use approximately 5 litres of water for 20 kg of powder.
– The adhesive is immediately ready-for-use and has a pot life of 2.0 hours.
– No further water should be added.
– Allow adhesive to slake for 5 minutes.

Note: Addition of REYNOBOND Latex partially or completely replacing water increases the bond strength and
flexibility of mortar

 

TECHNICAL DATA

IS Data
Property: Testmethod Requirement Typical Values
Tensile Adhesion
Dry Conditions –

Annex A (Clause5.1)

Minimum1.00 N/mm² 1.05-1.20 N/mm²
Wet Conditions –

Annex A (Clause5.1)

Minimum1.00 N/mm² 1.05-1.20 N/mm²
Dry Conditions –

Annex B (Clause 5.2)

Minimum1.25 N/mm² 1.25-1.40 N/mm²
Heat Ageing –

Annex B (Clause 5.2)

Minimum1.00 N/mm² 1.05-1.15 N/mm²
Wet Conditions –

Annex B (Clause 5.2)

Minimum1.00 N/mm² 1.10-1.20 N/mm²
Slip resistance-

Annex E (Clause 5.5)

≤ 0.5 mm 0.30-0.45 mm

Additional information

Colour

Grey

Working Properties at 21° C

REYNOSTYLE TAC 2T 315 Adhesive mixed with Water

Open Time

20 minutes

Pot Life

3 – 4 hours

Adjustment Time

20 Minutes

Time to Heavy Traffic

16 – 24 hours

Packaging

20 kg bags

Reviews

There are no reviews yet.

Be the first to review “REYNOSTYLE TAC 2T 315”

Your email address will not be published.